How To Install Your Heavy Duty Wall Hanger.

1.  Remember, no need to locate wall stud
because this hanger works without studs-
uses strength of wall panel to support weight!
Simply mark spot on wall where you want base of hook to be. Then mark second spot approximately 1/4" above first spot. This is point where hanger should be inserted.

2. "Drill" chisel end of hanger into wall by twisting hanger

back and forth. Force chisel point into wall as you twist. (On old-style plaster/lathe walls. pre drilling may be required.)

3. After chisel point passes through wall, twist hanger so hook end is upright. Then push balance of hanger into wall until only hook is visible. Hanger is now ready for use.

© The Gallery at Brookwood

The Gallery at Brookwood
5755 Cousins St
Austell, GA 30168
www.thegallery.us
770-941-3394